Features :

Single component sealing and bonding compound based on MS Polymer cross-linking with contact with the ambient humidity and having an incomparable transparency :

• Elastic seals around sanitary appliances: washbasins, basins, tubs and shower cubicles, bathtubs, sinks, bathroom furniture, marble(*) or granite(*) worktops. (*) The quality of these
• 2 materials being variable, a preliminary test is advised ]. Due to its composition, it is naturally resistant to moulds without the addition of anti-fungus.
• Gluing of heavy elements (bathtubs, washbasins, shower trays, shower enclosures...), and of elements of decoration (mirrors, shelves, towel racks, baseboards, mouldings...).

Implementation:

Preparation:

• The surfaces must be clean and degreased (depending on the surface, with alcohol or acetone per for example).

Instructions for use :

• Making a joint :

• For joints wider than 16 mm, it is generally recommended not to exceed half the width of the joint. width of the joint for the depth. For joints that are too deep, limit the depth with a foam cell phone.

• For bathtub joints subject to movement, avoid joints that are too small because the elongation of the is proportional to its thickness.

• Cut the end of the nozzle to a diameter slightly smaller than that of the joint.

• Smooth out within 10 minutes of application at the latest.

• Wait 2 to 3 hours before using sanitary appliances, 24 hours before direct water spray.

• Remove residues and softenedsealant residues with a dry cloth and the squeegee provided.

• Repeat the operation for large areas.

• Once the surface is stripped, rinse with water several times and dry.

• Then the new sealant can be applied.

• Making a collage :

• For plastic surfaces, it is best to remove the "shine" from the surface to be bonded by lightly abrasion (sandpaper or fine steel wool).
• Apply the product in a linear, zigzag or dotted pattern, covering the entire surface to be bonded and
• Avoiding thicker beads. On flat surfaces, beads of 2 mm diameter are (uncut cannula).
• Place the object to be fixed by pressing strongly.
• Maintain the glueing for about 1 minute (example of elements: wooden 3-holder coat hook, PVC soap holder, Wooden glass door, tiles 120x120mm²). Wait at least 12 hours before using the glued element.
• For heavy objects, support and wait at least 24 hours (time to be adapted according to the weight of the item) glued).
• Supports up to 20 kg/cm² (maximum value observed on an electro-galvanized steel to electro-galvanized steel bonding subjected to a tensile-shear stress).

Consumption :

• Depending on the size of the joint and the application, a 280 ml cartridge will produce a joint of length (the length of the joint is expressed in meters) :

Cleaning of equipment :

• Excess fresh, uncured filler can be removed with white spirit or acetone.

Product benefits:

• 3 functions in 1 product
• Waterproofing Adheres to all surfaces, even damp ones: enamel, synthetic materials, stoneware, steel, concrete, glass, etc.
• UV and mould resistant
• Aesthetics: ultra transparent
• Gluing: fixing of heavy elements
• Decoration: invisible joint and gluing of decorative elements

Tip:

• To make a joint, first mark the location of the joint by placing an adhesive tape that you can use to hold it in place. will be removed immediately after smoothing.