Application:

* Realization of seals (skimmers, projectors, nozzles, coping stones, verandas, shelters, ...), floor joints and expansion joints.
* Fixing of tiles, mosaics, friezes and other decorative elements.
* Repair of leaks on rigid structures and liners (with or without patching). Given the diversity of liners, a preliminary test should be carried out

Product benefits :

Very high performance
Can be applied underwater.
All supports.
Resistant to treated pool water.

Technical Features :

Color: white.
High initial adhesion.
Polymerizes under the action of air humidity, on wet surfaces and even directly under water.
Adheres perfectly to most common building and pool materials (except PE, PP PA, PTFE and bitumen). Resistant to treated swimming pool water, UV rays and bad weather. Not affected by frost or high temperatures (temperature resistance from -40°C to +90°C).

Instructions for use :

Creation of a joint:
For joints that are too deep, limit the depth with cellular foam.
Cut the end of the nozzle to a diameter slightly smaller than that of the joint.
Create maximum contact between the sealant and the lips of the joint by applying pressure to the surface of the bead.
Smooth out within 5 minutes of application.
Making a collage :
For plastic surfaces, it is preferable to remove the "shine" of the surface to be bonded by lightly abrading with the POOL* ABRASIVE TAPE.
Apply the product in spaced linear beads or in dots covering the entire surface to be bonded and avoiding large thicknesses. On flat surfaces, beads of 2 mm in diameter are adequate (uncut nozzle).
Place the object to be fixed by pressing strongly. In most cases, a support is not necessary.
Immersion:
In the case of a joint or clogging, smooth it out immediately.
For bonding, if possible, coat the surfaces to be bonded out of the water and apply with strong pressure under water.