Descaling agent for domestic hot water accumulators

• FIELD OF APPLICATION

Descaling of the hot water tank.

Descaling of the hot and cold water pipes of the generator.

• USE

Drain the tank completely and disconnect the hot and cold water lines.

Using a funnel, slowly pour 9 L of product into the cold water opening, interrupting regularly to allow the descaler to act in the pipe. Proceed in the same way with the rest of the canister (1 L) in the hot water orifice and leave it to act for 15 to 20 minutes.

Connect the cold water line and flush the tank using the drain valve at the bottom of the unit.

Connect the hot water pipe. Close the drain valve and drain the tank: let the water run so that the generator is perfectly rinsed (when the water is transparent, without foam, the tank is clean).

In order to see the water better, remove the aerator from the tap.

• SPECIAL FEATURES

The DESCALING AGENT FOR HOT WATER ACCUMULATORS does not attack gaskets, rubber, copper, brass or mesh.

DO NOT RINSE THE BALLOON OVER A STAINLESS STEEL SINK : the descaling agent may stain the stainless steel.

It is advisable to carry out an annual descaling in order to keep the balloon in perfect condition.

• SECURITY

R34 Causes burns.

R37 Irritating to respiratory system.

S2 Keep out of reach of children.

S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.

• ENVIRONMENT

Biodegradable product at more than 95 %.

Recyclable packaging.

• Item code MS0610 for the 10 litre can.